GRAPHTEC FC2250 Series User Manual page 55

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
To perform manual axs adjustment usng a pre-prnted frame or other marks on the medum as reference ponts,
press the [F2] key (AXIS).
To perform automatc or manual detecton of the regstraton marks, press the [F4] key (MARKS).
When the dsplayed settng s satsfactory, press the [ENTER] key to confirm your selection.
(5) When the [F2] key (AXIS) or [F4] key (MARKS) s pressed, the axs adjustment menu s dsplayed.
FORCE
2 POINT
SPEED
Press the [F2], [F3] or [F4] key to dsplay the black dot next to your desred mode and then press the [ENTER] key
to confirm your selection. If AXIS was selected for the registration mark mode the plotter returns to Ready status.
(6) If MARKS was selected for the regstraton mark mode, the MARK MOVE No. menu s dsplayed.
FORCE
MARK MOVE No.
SPEED
By specfyng the dstance between regstraton marks and not performng scannng n the areas where there are no
regstraton marks, ths functon enables a reducton n the tme requred to read regstraton marks and also prevents
the msreadng of drt or other foregn matter on the medum as a regstraton mark. Up to three settngs can be
regstered.
(7) Use the [ ] or [
and then press the [ENTER] key.
FORCE
MARK MOVE No.
SPEED
(8) Next, the MARK MOVE DIST. menu s dsplayed.
FORCE
MARK MOVE DIST.
X=0000mm
SPEED
Use the [ ] or [
the [ENTER] key to confirm your selections.
Registration mark pattern 1
Specify [Y]
Specify [X]
If there s no need to skp readng between regstraton marks, specfy X = 0, Y = 0 (the default values). If 0 mm s
specified for the spacing, the plotter will not skip reading between registration marks. It will continue searching until
the next regstraton mark s found.
If 2-point reading has been selected, the Y numeric value is disregarded.
4-4
OFFSET
3 POINT
4 POINT•
QUALITY
OFFSET
No.=1
QUALITY
] key to move through the selectons "1", "2," and "3". Select the number that you wsh to regster
OFFSET
No.=1
QUALITY
OFFSET
Y=0000mm
QUALITY
] key to move the blnkng cursor, and the [
Registration mark pattern 2
Specify [Y]
] or [
Specify [X]
] key to change the numerc value. Press
Registration mark pattern 3
Specify [Y]
Specify [X]