PerforatOn SettNgs - GRAPHTEC FC2250 Series User Manual

(4) The actve mode s ndcated by the [
Mode 2 and select the desred mode.
Mode 1: Perform overcuttng for the cuttng start and end ponts and for corners wth acute angles to prevent uncut
areas. Snce the blade tp s rased up to the surface of the medum when blade rotaton s large, t s not
affected by thick or hard media. Compared with Mode 2, this mode supports finer cutting and cutting of
thcker meda.
Mode 2 : Perform overcuttng for the cuttng start and end ponts only. Compared wth Mode 1, ths mode supports
faster cuttng, snce less cutter blade control s requred.
(5) Use the [F2] key to move the blnkng cursor to the Start pont parameter and the [F4] key to move t to the End
pont parameter. Use the [
Setting range: 0 to 3.0 mm
(6) When the dsplayed settngs are correct, press the [ENTER] key. The dsplay wll change to the screen for settng
the perforaton length. To cancel your settngs, press the [NEXT] key.
Perforation Settings
Ths settng determnes the cut and uncut lengths of a perforated lne. Ths settng s only enabled for the
COND Nos. to whch the perforaton mode has been assgned.
•
The perforation settings are disabled when "PEN", "CP001" or "CP002" has been selected as the cutter blade type.
•
Please see Section 5.10, "Assigning Perforation Cutting" for further details.
(1) When perforation cutting has been specified, "M" is displayed next to the Tool No. when the plotter is in Ready status.
FORCE
20,20 COND1
30 READY+ TOOL1M
SPEED
(2) Press the [CONDITIONS] key to dsplay the followng screen. (The dsplay wll dffer accordng to the settng
condtons that have been made.)
FORCE
X20 COND1
30 CHANGE TOOL1
SPEED
(3) Press the [ENTER] key to dsplay the Thck Mode mode selecton screen (only when Thck Mode assgnment has
been performed).
FORCE
•MODE THICK MODE2
STR.=0.0mm END=0.0mm
SPEED
(4) Press the [ENTER] key to dsplay the screen for settng the Perforaton Mode values.
FORCE
C LINE PAT.SETTING
C=00.25mm
SPEED
(5) "C" represents the cut length, whle "U" represents the uncut length, Use the [
cursor to the parameter that you wsh to change, and the [
Setting range: 0 to 99.99 mm
(6) When the dsplayed settngs are correct, press the [ENTER] key. To cancel your settngs, press the [NEXT] key.
•
] mark. Press the [F1] and [F3] key to move the [
] or [ ] key to change the value.
OFFSET
09U 0
4
QUALITY
OFFSET
09U 0
4
QUALITY
OFFSET
QUALITY
OFFSET
U=00.25mm
QUALITY
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
] or [
] or [ ] key to change the value.
•
] mark between Mode 1 and
] key to move the blnkng
3-15