GRAPHTEC FC2250 Series User Manual page 49

3.12 Using the Copy Function
Ths functon allows you to automatcally cut duplcates of the data sent from the computer. Once the data
has been stored n the plotter's receve buffer, t can be repeatedly cut.
(1) Send data to the plotter and then perform a cuttng operaton to enable the data to be stored n the plotter's buffer.
(2) Set the COPY orgn. Use the [
current settng) to the desred startng poston for cuttng copes.
(3) Press the [COPY] key to select COPY mode. The followng screen for settng the number of copes appears.
FORCE
COPY MODE
COUNT
SPEED
(4) Use the [ ] or [
hgher than the maxmum number of copes that can be cut out of the currently loaded medum.
(5) Press the [ENTER] key to start makng copes.
(6) If you wsh to set the spacng between copes, press the [COPY] key agan. The followng screen for settng the
spacng between copes appears.
FORCE
COPY SPACE
SPEED
(7) Use the [ ] or [
Setting range: 1 to 10 (mm)
Your COPY SPACE settng s regstered n the plotter's nternal memory and retaned even whle the plotter s turned
off.
(8) Press the [ENTER] key to regster your COPY SPACE settng and return to the dsplay shown n Step 3.
(9) The "COPY" message is displayed and the plotter begins cutting the specified number of copies.
(10) If you wsh to contnue cuttng more copes, reload a cuttng medum and press the [COPY] key to start over agan
from settng the number of copes.
(11) If the data to be copied will not fit within the effective cutting area, the message below appears.
FORCE
CANNOT COPY!
SPEED
(12) In ths case, use the [
loaded medum wth a larger sheet.
If the Registration Mark mode has been specified, the registration marks are detected and only one copy is made.
] [ ] [ ] [
OFFSET
1
QUALITY
] key to set the desred number of copes to be made. Be sure to set the number of copes no
OFFSET
1mm
QUALITY
] key to set the spacng between copes.
OFFSET
QUALITY
] [ ] [ ] [ ] keys to move the startng poston for cuttng copes orgn or replace the
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
] keys to move the pen carrage (the tp of the tool selected by the
3-21