User (Manual Input) - GRAPHTEC FC2250 Series User Manual

4.4 Registration Mark Distance Adjustment
The dstance between regstraton marks can be adjusted automatcally. If 5 mm was selected for CUSTOM,
for example, and the dstance between regstraton marks was read as 312 mm, any dstance less than 5
mm s rounded off to the nearest whole number. In ths case, the dstance between the regstraton marks s
assumed to be 310 mm and dstance adjustment s performed accordngly.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly untl the followng menu s dsplayed.
FORCE
MARK
BUFFER CLR.
SPEED
(3) Press the [F1] key (MARK) to dsplay the regstraton mark functons selecton menu.
FORCE
MODE
TYPE OTHER SETUPS
SPEED
(4) Press the [F3] key (DIST ADJ) to dsplay the regstraton mark dstance adjustment menu.
FORCE
•USER
SPEED
The currently selected settng s ndcated by a black dot [
For manual dstance adjustment, press the [F2] key (USER).
For custom dstance adjustment, press the [F3] key (CUSTOM).
For automatc dstance adjustment, press the [F4] key (STANDARD). The dstance adjustment value s rounded up
or down to the nearest 5 mm, 10 mm, or 50 mm accordng to the regstraton mark dstance settng.
USER
(Manual Input)
(1) Perform regstraton mark detecton. (See Secton 4.13, "Regstraton Mark Detecton".
(2) After detecton of the number of ponts set n the regstraton mark mode has been performed, the menu shown
below s dsplayed.
FORCE
1-2M
S
SPEED
The display's first line (M) shows the distance between points 1 and 2 as read by the plotter. Input the actual
dstance (the data dstance) n the second lne (S). Use the [
dsplayed settng s satsfactory, press the [ENTER] key.
If the value you nput s exceedngly large (1.5 tmes or greater) or very small (0.5 tmes or less), or f the angle of tlt
wth respect to the orgnal axs tlt s 45° or greater, the followng prompt s dsplayed. In ths case, please re-nput
the value.
FORCE
DISTANCE ADJUSTMENT
ERROR. SET AGAIN!
SPEED
OFFSET
TOOL U/D
VIEW
QUALITY
OFFSET
DIST ADJ
QUALITY
OFFSET
CUSTOM
STANDARD
QUALITY
OFFSET
00499.8 mm
00500.0 mm
QUALITY
OFFSET
QUALITY
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
•
].
] or [ ] key to change the numerc value. When the
4-7