GRAPHTEC FC2250 Series User Manual page 86

Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.9 Assigning Tool Numbers
Ths functon enables you to assgn tool holder 1 and tool holder to COND Nos. 1 to 8.
If the application software is used to perform pen exchange operations, "PROGRAM" must be selected for the
CONDITION PRIORITY setting (please see Section 5.27, "Using the Special Functions").
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly untl the followng menu s dsplayed.
FORCE
I/F
TOOL COND AREA OPT
SPEED
(3) Press the [F2] key (TOOL COND) to dsplay the menu shown below.
FORCE
THICK
TOOL No. ADJ.T POS
SPEED
(4) Press the [F2] key (TOOL No.) to dsplay the tool number assgnment settng screen.
FORCE
COND
TOOL
SPEED
The upper row of the dsplay represents the cuttng condton COND Nos. Use the [
blnkng cursor underneath the CONDITION No. for whch you wsh to change the current tool assgnment, and then
use the [ ] or [
The factory default settngs are those shown n the above screen.
Press the [ENTER] key to confirm your selections.
(5) Press the [PAUSE] key to cancel PAUSE mode.
These settings are retained in the plotter's internal memory even while the plotter is turned off.
5-10
OFFSET
FUNCTION
QUALITY
OFFSET
CUT LINE
QUALITY
OFFSET
No. 12345678
No. 11112222
QUALITY
] key to toggle the tool number between 1 and 2.
] or [ ] key to move the