GRAPHTEC FC2250 Series User Manual page 115

GP-GL Command Mode Error Messages
If any of the followng error messages are dsplayed, one of the followng reasons s lke to be the cause:
(1) The software's output or nterface settngs have been changed.
g Configure the software for output by this plotter.
g Ensure that the software's nterface settngs are correctly set.
(2) The plotter's nterface settngs have been changed.
g Ensure that the plotter's nterface settngs are correctly set.
Error message
ERROR 1
COMMAND ERROR !
ERROR 4
PARAMETER OVERFLOW
ERROR 5
I/O ERROR !
Cause
The plotter received an unrecognizable
command.
•
The software's output or nterface settngs
have been changed.
•
The plotter's nterface settngs have been
changed.
A command contanng a numerc parameter
that exceeds that command's permssble
range was receved.
•
The software's output or nterface settngs
have been changed.
•
The plotter's nterface settngs have
been changed.
An nterface-related error occurred durng
data transfer.
•
The software's output or nterface settngs
have been changed.
•
The plotter's nterface settngs have
been changed.
Chapter 6 TROUBLESHOOTING
Solution
Configure the software for output by this
plotter.
Ensure that the software's nterface settngs
are correctly set.
Ensure that the plotter's nterface settngs
are correctly set.
Configure the software for output by this
plotter.
Ensure that the software's nterface settngs
are correctly set.
Ensure that the plotter's nterface settngs
are correctly set.
Configure the software for output by this
plotter.
Configure the software for output by this
plotter.
Ensure that the software's nterface settngs
are correctly set.
Ensure that the plotter's nterface settngs
are correctly set.
6-5