Creaser SettNgs - GRAPHTEC FC2250 Series User Manual

Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(6) When the dsplayed settngs are correct, press the [ENTER] key. To cancel your settngs, press the [NEXT] key.
Creaser Settings
The creaser settngs enable you to specfy the creasng mode, the spacng between creases, the number of
creasng operatons and the creasng start and end ponts.
Only straight lines can be creased. Curved-line data cannot be creased.
(1) The followng Creaser Settngs screen s dsplayed when "CP-001" was selected as the cutter blade type and the
[ENTER] key pressed.
If "CP-002" was selected, the Thck Mode Settngs screen s dsplayed (when thck mode assgnment has been
enabled). In ths case, make the requred thck mode settngs and then press the [ENTER] key.
FORCE
MODE1
SPC -.--mm ST 0.00mm
SPEED
Setting the Creasing Mode
(2) Press the [F2] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE
MODE1
SPC -.--mm ST 0.00mm
SPEED
(3) The number dsplayed next to "MODE" s the number of the mode that s currently selected. Use the [
key to select your desred mode.
Selectable parameters: MODE 1. MODE 2, MODE 3
Actual Data
Modes 2 and 3 enable thck meda to be bent easly.
Setting the Spacing
(4) Press the [F2] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
The spacing parameter is only enabled for Modes 2 and 3. The blinking cursor does not move when Mode 1 has
been selected.
3-12
OFFSET
COUNT1
QUALITY
OFFSET
COUNT1
QUALITY
Mode 1 (Crease one line)
Crease lines at the same position
as the actual data.
OFFSET
COUNT1
QUALITY
Mode 2 (Crease two lines)
Actual data
Crease lines at positions on either side
of the actual data. (Creasing is not
performed at the actual data position)
] or [ ]
Mode 3 (Crease three lines)
Actual data
Crease lines at the same position
as and on either side of the actual
data.