GRAPHTEC FC2250 Series User Manual page 41

(5) Use the [ ] or [ ] key to move the poston of the blnkng cursor, and the [
Setting range: 0 to 9.99 mm
Mode 2 (Crease two lines)
Spacing
Actual data
(creasing is not performed
at the actual data position)
Setting the Number of Creasing Operations
(6) Press the [F3] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
(7) Ths settng determnes how many tmes creasng should be repeated for each lne segment. Use the [
key to select the value.
Setting range: 1 to 9 (times)
Setting the Start and End Positions
(8) Press the [F4] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
(9) Ths settng determnes by what margn each end of the creasng lne falls short of the correspondng end of the actual
data lne. Use the [
the [ENTER] key to confirm your selections.
Setting range: 0 to 9.99 (mm)
CP-001
Specified value
Actual data
(10) When all the dsplayed values are correct, press the [ENTER] key. To cancel your settngs, press the [NEXT] key.
For short-line data such as circle command data, setting a large value for the ST (Start) parameter may result in creasing
not being performed.
Mode 3 (Crease three lines)
Actual data
OFFSET
COUNT1
QUALITY
OFFSET
COUNT1
QUALITY
] or [ ] key to move the blnkng cursor, the [
CP-002/003
Medium
Actual data
Spacing
] or [
Medium
Specified value
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
] or [ ] key to select the value.
] key to change the numerc value and
] or [ ]
3-13