GRAPHTEC FC2250 Series User Manual page 84

Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.7 Assigning THICK Mode
Ths functon allows you to assgn the THICK mode to COND Nos. 1 to 8. THICK mode s used for cuttng
thck meda such as maskng rubber for sandblastng, thck pattern paper for apparel desgn as well as for
hard media such as acrylic film.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly untl the followng menu s dsplayed.
FORCE
I/F
TOOL COND AREA OPT
SPEED
(3) Press the [F2] key (TOOL COND) to dsplay the menu shown below.
FORCE
THICK
TOOL No. ADJ.T POS
SPEED
(4) Press the [F1] key (THICK) to dsplay the menu shown below.
FORCE
THICK No.
OVERLAY
SPEED
(5) Press the [F2] key (THICK No.) to dsplay the THICK mode assgnment settng screen.
FORCE
COND. No. 12345678
THICK
SPEED
Blinking cursor
The upper row of the dsplay represents the cuttng condton COND Nos. A check mark [ ] s dsplayed for any of
the COND. Nos. to whch THICK mode has been assgned.
Use the [ ] or [
the [ ] or [
Press the [ENTER] key to confirm your selection.
(6) Press the [PAUSE] key to cancel PAUSE status.
(7) When THICK mode has been assgned to a condton number, the blnkng cursor appears over the Tool No. when
the plotter s n Ready status.
FORCE
20,20 COND1
30 READY+ TOOL1
SPEED
•
THICK mode is disabled when "PEN" or "CP-001" has been selected as the cutter blade type.
•
Please see Section 3.8, "Setting the Cutting Conditions" for details on THICK mode settings.
5-8
OFFSET
FUNCTION
QUALITY
OFFSET
CUT LINE
QUALITY
OFFSET
QUALITY
OFFSET
QUALITY
] key to move the blnkng cursor to the COND. No. that you want to assgn THICK mode to, and
] key to dsplay or hde the check mark [ ].
OFFSET
09U 0
4
QUALITY