Programmed Scan Operation; F Scan Operation - Icom ic-7700 Instruction Manual

9
SCANS

■ Programmed scan operation

[SQL]
PROG
F-1
■ ∂F scan operation
[SQL]
∂F ∂F SCAN
F-2
EXIT/SET Main dial
EXIT/SET
Main dial
F-4
q Push
EXIT/SET
tion screen, if necessary.
w Select VFO mode.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Push [SCAN]
F-5
t Set [SQL] open or closed.
• See page 9-2 for squelch condition.
y Push [PROG]
F-1
• "
PROGRAM SCAN
scanning.
u When the scan detects a signal, scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
i To cancel the scan, push [PROG]
• Rotating the main dial also cancels the scan.
o Hold down [RECALL]
the frequency that is set before starting the scan, if
desired.
If the same frequencies are programmed into
the scan edge memory channel P1 and P2, pro-
grammed scan will not start.
q Push EXIT/SET
tion screen, if necessary.
w Select VFO mode or a memory channel.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Push [SCAN]
F-5
t Set the main band's [SQL] open or closed.
• See page 9-2 for squelch condition.
y Set the ∂F span by pushing [∂F SPAN]
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500
kHz and ±1000 kHz are selectable.
u Set center frequency of the ∂F span.
i Push [∂F] F-2
• " F SCAN " and decimal points blink while scanning.
:
o When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
!0 To cancel the scan, push [∂F]
• Rotating the main dial also cancels the scan.
!1 Hold down [RECALL]
the frequency that was set before starting the scan.
9-4
several times to close a multi-func-
to select the scan screen.
to start the programmed scan.
" and decimal points blink while
F-1
for 1 second to recall
F-6
several times to close a multi-func-
to select the scan screen.
to start the ∂F scan.
.
F-2
for 1 second to recall
F-6
.
.
F-4