D Ip Address Setting - Icom ic-7700 Instruction Manual

D IP address setting

∫ √ OTHERS
Ω ≈
F-1 F-2 F-3 F-5
EXIT/SET
SET
F-7
UPDATING THE FIRMWARE
When updating the firmware from the USB flash
drive, the following settings are not necessary.
IMPORTANT! A fixed (static) IP address is used for
the IC-7700.
When you connect the IC-7700 to a LAN, ask the
network manager about a usable/assignable IP
address and the subnet mask in advance.
NEVER use an IP address that has already been
used with another device in the network. If the IP
address is duplicated, the network will crash.
q Push
EXIT/SET
tion screen, if necessary.
w Push [SET]
F-7
e Push [OTHERS]
r Push [Y]
F-1
"IP Address" item.
t Push [t u] F-3
rotate the main dial to set the desired or specified
IP address.
• "192.168.0.10" is the default setting.
y Push [Z]
F-2
u Rotate the main dial to set the desired or specified
subnet mask.
• "255.255.255.0" is the default setting.
i Push to turn the transceiver power OFF,
POWER
then ON to enable the IP address and subnet
mask settings.
16-7
several times to close a multi-func-
to select set mode menu screen.
to select Others set mode.
F-5
or [Z] several times to select
F-2
to select the desired part then
to select "Subnet Mask" item.
16