Sending A Recorded Message; D Single Tx; D Repeat Tx - Icom ic-7700 Instruction Manual

■ Sending a recorded message

D Single TX

T1 T2 T3
F-1 F-2 F-3
Appears

D Repeat TX

T1 T2 T3
F-1 F-2 F-3
Appears Repeat indicator
For your convenience
✔
When an external keypad or PC keyboard is connected, the recorded message, T1 to T4, can be transmitted
without opening the Voice Recorder screen. See pages 2-6, 2-7 and 12-17 for details.
• The recorded message, T1 to T4 is transmitted once when pushing one of four switches on the external keypad; the re-
corded message is repeatedly transmitted when holding down a switch.
• The recorded message, T1 to T4 is transmitted once when pushing one of [F1] to [F4] key on the PC keyboard; the re-
corded message is repeatedly transmitted when pushing a key while holding down [SHIFT] key.
EXIT/SET
T4 T/R
F-4 F-7
Counts down
EXIT/SET
T4 T/R
F-4 F-7
VOICE RECORDER FUNCTIONS
q Push EXIT/SET
tion screen, if necessary.
w Select a phone mode by pushing
e Push [VOICE]
menu.
r Push [PLAY]
screen.
• If the receive voice message appears, push [T/R]
to select TX message (T1–T4).
t Push a desired message switch, [T1]
[T4] , to transmit the contents.
F-4
• The transceiver transmits automatically.
• " " indicator appears and the memory timer
SEND
counts down.
• You hear the transmitted message from the speaker as
the default. This can be turned OFF in voice set mode.
(p. 7-13)
y Push the selected message switch, [T1]
[T4] , again to stop, if desired.
F-4
• The transceiver returns to receive automatically when all
of the recorded contents in the message are transmit-
ted.
u Push
EXIT/SET
screen.
q Perform steps q to r above.
w Hold down a desired message switch, [T1]
[T4] , for 1 second to repeatedly transmit the
F-4
recorded voice audio for up to 10 minutes at the
interval specified in "Repeat Time."
• Even if 10 minutes pass while transmitting, the voice
audio is completely transmitted.
• One of the following steps will cancel the transmission.
- Push the memory again.
- Push another memory (except for [TX LEV.]).
- Exit the TX Voice memory screen.
- Turn OFF the power, then turn it ON again.
- Activate the transmission.
The repeat transmission is cancelled. But while trans-
mitting, the voice audio is completely transmitted.
• Once the Repeat TX is made, the transceiver pauses
until the end of the "Repeat Time," then transmits again.
After the second transmission, the Repeat TX continues
pausing, if receiving a signal. But if the squelch is manu-
ally opened, the voice audio is repeatedly transmitted,
according to the repeat time setting.
7-11
several times to close a multi-func-
SSB
F-2
to enter the Voice recorder
to enter the Voice recorder
F-1
twice to exit the voice memory
7
or .
AM/FM
F-7
to
F-1
to
F-1
to
F-1