Programmed Scan; D Programmed Scan Operation - Icom IC-9700 Advanced Manual

5. SCANS

Programmed scan

Programmed scan and Fine Programmed scan
Scan edge
1A ~ 3A
Repeatedly scans between two Scan Edge
frequencies (1A/1B ~ 3A/3B channels).
L To change the Scan Edge Memory channels, see
"Entering memory channel contents" (p. 4-2) for details.
L If the same frequencies are entered into the
Scan Edge Memory channels, the Programmed
scan does not start.
L The Fine Programmed scan is most effective in
the SSB, CW, and RTTY modes.
Scan edge
1B ~ 3B
Scan
Jump

D Programmed scan operation

1. Select the VFO mode.
2. Select the operating mode and tuning step.
(Example: USB, 1 kHz)
3. Display the SCAN screen.
» SCAN
MENU
4. Touch [PROG] for 1 second.
5. Touch the frequency range to scan (example: P1)
• The Programmed scan starts.
L When a signal is detected, the scan pauses
according to the "SCAN Resume" setting, and then
resumes.
L You can change the tuning step by touching kHz.
LTo cancel the scan, touch [PROG].
6. Touch [FINE] to switch to the Fine Programmed
scan.
• The tuning step changes to the 50 Hz step.
L When a signal is detected, the tuning step changes
to the 10 Hz step.
L Touch [FINE] again to return to the Programmed scan.
7. To close the SCAN screen, push
5-4
Blinks
Blinks
Blinks
.
EXIT