Programmed Scan Operation; Memory Scan Operation - Icom ic-718 Instruction Manual

7
SCANS
 Programmed scan operation
q Select the VFO mode by pushing [V/M].
w Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e Set [RF/SQL] open or closed.
• See the previous page for scan details.
• If the [RF/SQL] control function is set as RF control,
the squelch always opens. See pages 15, 20 for de-
tails.
r Push [SCAN] to start the programmed scan.
• "SCAN" appears while scanning.
t When the scan detects a signal, the scan stops,
pauses or ignores it, depending on the resume
setting and the squelch status.
y To cancel the scan, push [SCAN].
If the same frequencies are programmed into the
P1 and P2 scan edges Memory channels, the scan
does not start.
 Memory scan operation
q Select Memory mode by pushing [V/M].
w Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e Set [RF/SQL] open or closed.
• See previous page for scan details.
• If the [RF/SQL] control function is set as an RF con-
trol, the squelch is always opened. See pages 14, 30
for details.
r Push [SCAN] to start the memory scan.
• "SCAN" appears while scanning.
t When the scan detects a signal, the scan stops,
pauses or ignores it, depending on the resume
setting and the squelch status.
y To cancel the scan, push [SCAN].
2 or more Memory channels must have entered
content for memory scan to start.
40