Set The Time And Date Display - Polycom CX5500 Administrator's Manual

Polycom CX5500 Unified Conference Station Administrator's Guide
This configuration results in the following speed dial keys on the phone.

Set the Time and Date Display

A clock and calendar are enabled by default. You can display the time and date for your time zone in
several formats, or you can turn it off altogether. You can also set the time and date format to display
differently when the phone is in certain modes. For example, the display format can change when the
phone goes from idle mode to an active call. You will have to synchronize the phone to the Simple
Network Time Protocol (SNTP) time server. Until a successful SNTP response is received, the phone will
continuously flash the time and date to indicate that they are not accurate.
The time and date display on phones in PSTN mode will be set by an incoming call with a supported
Caller ID standard, or when the phone is connected to Ethernet and you enable the turn on the date and
time display.
Set the Time and Date Display
Central Provisioning Server
Turn the time and date display on or off.
Set the time and date display format.
Display time in the 24-hour format
Set the basic SNTP settings and daylight savings
parameters.
Web Configuration Utility
To set the basic SNTP and daylight savings settings navigate to Preferences > Date & Time.
Local Phone User Interface
Basic SNTP settings can be made in the Network Configuration menu—see DHCP Menu or Network Interfaces
Menu (Ethernet Menu)
To set the time and date format and enable or disable the time and date display, tap Settings > Basic >
Preferences > Time & Date.
Polycom, Inc.
template > parameter
reg-advanced.cfg and site.cfg >
site.cfg > lcl.datetime.date.*
site.cfg > lcl.datetime.time.24HourClock
site.cfg > tcpIpApp.sntp.*
1.1.0
up.localClockEnabled
86