Ptt; Qos - Polycom CX5500 Administrator's Manual

Polycom CX5500 Unified Conference Station Administrator's Guide
<ptt/>
The parameters in the table
Group Paging Parameters
Parameter
ptt.address
The multicast IP address to send page audio to and receive page audio from.
ptt.pageMode.enable
If 0, group paging is disabled. If 1, group paging is enabled.
ptt.pageMode.displayName
This display name is shown in the caller ID field of outgoing group pages. If Null, the value from
reg.1.displayName will be used.
ptt.pageMode.group.x.available
Make the group available to the user
ptt.pageMode.group.x.allowTransmit
Allow outgoing announcements to the group
ptt.pageMode.group.x.label
The label to identify the group
ptt.pageMode.group.x.subscribed
Subscribe the phone to the group
A page mode group x, where x= 1 to 25. The label is the name used to identify the group during pages.
If available is disabled (0), the user cannot access the group or subscribe and the other page mode group
parameters will be ignored. If enabled, the user can access the group and choose to subscribe.
If allowTransmit is disabled (0), the user cannot send outgoing pages to the group. If enabled, the user may
send outgoing pages.
If subscribed is disabled, the phone will not be subscribed to the group. If enabled, the phone will subscribe to the
group.
<qos/>
These parameters listed in the table
Quality of Service (QoS) options:
●
The 802.1p/Q user_priority field RTP, call control, and other packets
The "type of service" field RTP and call control packets
●
Polycom, Inc.
Group Paging Parameters
Permitted Values
multicast IP address
Quality of Service (Type of Service) Parameters
apply to page mode.
0 or 1
up to 64 octet UTF-8 string
0 or 1
0 or 1
string
0 or 1
Default
224.0.1.116
0

PTT

1
1
ch24: Priority,
ch25: Emergency, others:
Null
ch1, 24, 25: 1, others: 0
control the following
1.1.0
283