Polycom CX5500 Administrator's Manual page 320

Polycom CX5500 Unified Conference Station Administrator's Guide
Parameter
up.headsetAlwaysUseIntrinsicRinger
If 1, the USB headset will use the intrinsic ringer mixed with DSP ringer when the sound effect destination is the
USB headset.
up.headsetMode
If 0, handsfree mode will be used by default instead of the handset. If 1, the headset will be used as the preferred
audio mode after the headset key is pressed for the first time, until the headset key is pressed again.
up.headset.phoneVolumeControl
Controls the phone's behavior when you adjust volume at the headset.
enable – The phone responds to volume up/down events from the headset by displaying the volume widget in
the phone's user interface and adjusting the phone's internal volume.
disable – The phone ignores volume up/down events from the headset; pressing the headset's volume controls
has no effect on the phone.
auto – The phone automatically selects which of the above two behaviors to apply based on the type and model
of headset that you attach.
up.hearingAidCompatibility.enabled
If set to 1, the phone audio Rx (receive) equalization is disabled for hearing aid compatibility. If 0, audio Rx
equalization is enabled.
up.idleBrowser.enabled
If 0, the idle browser is disabled. If 1, the idle browser is enabled (if up.prioritizeBackground.enable is 1,
the user can choose to display the background or the idle browser through the phone menu).
1
up.idleStateView
Sets the default view on the phone.
If 0, The call/line view is the default view. If 1, the Home screen is the default view.
1
up.idleTimeout
The number of seconds that the phone can be idle for before automatically leaving a menu and showing the idle
display. If 0, there is no timeout and the phone does not automatically exit to the idle display.
up.IdleViewPreferenceRemoteCalls1
Use this parameter to determine when the phone displays the idle browser.
When set to 1, a phone with only remote calls active, is treated as in the active state and the idle browser does
not display.
When set to 0, a phone with only remote calls active, is treated as in the idle state and the idle browser displays.
up.lineKeyCallTerminate
If 1, the user can press a line key to end an active call on that line. If 0, the user cannot end a call by pressing the
line key (this is the previous behavior).
up.localClockEnabled
If 0, the date and time are not shown on the idle display. If 1, the date and time and shown on the idle display.
Polycom, Inc.
Permitted Values
0 or 1
0 or 1
1
disable, enable, auto
0 or 1
0 or 1
0 or 1
0 to 65535, seconds
0 or 1
0 or 1
0 or 1
1.1.0
Default
1
0
auto
0
0
0
40
0
0
1
320