Polycom CX5500 Administrator's Manual page 319

Polycom CX5500 Unified Conference Station Administrator's Guide
Parameter
tone.chord.callProg.x.repeat
tone.chord.misc.x.repeat
tone.chord.ringer.x.repeat
The number of times each ON/OFF cadence is repeated, 0=infinite.
<up/>
Use the parameters listed in the table
phones.
User Preferences Parameters
Parameter
up.25mm
Specify whether to use a mobile phone or a PC to connect to the 2.5mm audio port on a conference phone. Set
to 1 if using a mobile phone. Set to 2 if using a PC.
up.analogHeadsetOption
The Electronic Hookswitch mode for the phone's analog headset jack. 0 - no EHS-compatible headset is
attached. 1 - a Jabra EHS-compatible headset is attached. 2 - a Plantronics EHS-compatible headset is
attached. 3 - a Sennheiser EHS-compatible headset is attached.
up.audioMode
If 0, a handset is connected. If 1, a headset is connected.
up.backlight.idleIntensity
The brightness of the LCD backlight when the phone is idle. 0 – off, 1 – low, 2 – medium, 3 – high. Note: If this is
higher than the active backlight brightness (onIntensity), the active backlight brightness is used.
up.backlight.onIntensity
The brightness of the LCD backlight when the phone is active (in use). 0: off, 1 – low, 2 – medium, 3 – high
up.backlight.timeout
The number of seconds to wait before the backlight dims from the active intensity to the idle intensity.
up.cfgWarningsEnabled
If 1, a warning is displayed on the phone if the phone is configured with pre-UC software 3.3.0 parameters. If 0,
the warning will not display.
up.handsfreeMode
If 0, the handsfree speakerphone is disabled (cannot be used). If 1, the handsfree speakerphone is enabled.
Polycom, Inc.
Permitted Values
positive integer
positive integer
positive integer
User Preferences Parameters
Permitted Values
1 or 2
0, 1, 2, 3
0 or 1
0, 1, 2, or 3
0, 1, 2, or 3
5 to 60
0 or 1
0 or 1
to set user preferences on the
Default
1
0
0
1
3
40
0
1
1.1.0
319