Polycom CX5500 Administrator's Manual page 321

Polycom CX5500 Unified Conference Station Administrator's Guide
Parameter
1
up.mwiVisible
If set is 0, the incoming MWI notifications for lines where the MWI callback mode is disabled
(msg.mwi.x.callBackMode is set to 0) are ignored, and do not appear in the message retrieval menus.
If set to 1, the MWI for lines whose MWI is disabled will display (pre-SIP 2.1 behavior), even though MWI
notifications have been received for those lines.
1
up.numberFirstCID
If 0, the caller ID display will show the caller's name first. If 1, the caller's phone number will be shown first.
up.numOfDisplayColumns
Set the maximum number of columns the CX5500 system displays. Note that phones display one column when
the value is set to 0. The maximum number of columns for the CX5500 system is 4.
up.offHookAction.none
If 0, the behavior will be as it was in SIP 2.1.2. If 1, when the user lifts the handset, the phone will not seize the
line and the ringer will continue until the user takes further action.
up.oneTouchVoiceMail
If set to 1, the voicemail summary display is bypassed and voicemail is dialed directly (if configured).
up.screenCapture.enabled
If 0, screen captures are disabled. If 1, the user can enable screen captures from the Screen Capture menu on
the phone. Note: when the phone reboots, screen captures are disabled from the Screen Capture menu on the
phone.
up.screenSaver.enabled
. If 0, the screen saver feature is disabled. If 1, the screen saver feature is enabled. If a USB flash drive
containing images is connected to the phone, and the idle browser is not configured, a slide show will cycle
through the images from the USB flash drive when the screen saver feature is enabled. The images must be
stored in the directory on the flash drive specified by up.pictureFrame.folder. The screen saver displays
when the phone has been in the idle state for the amount of time specified by up.screenSaver.waitTime.
up.screenSaver.type
The type of screen saver. If 0, the screen saver feature is disabled. If 1, a blank screen is used, If 2, the idle
browser is used as the screen saver.
up.screenSaver.waitTime
. The number of minutes that the phone waits in the idle state before the screen saver starts.
up.simplifiedSipCallInfo
If 1, the displayed host name is trimmed for both incoming and outgoing calls and the protocol tag/information is
not displayed for incoming and outgoing calls.
up.useDirectoryNames
If 0, names provided through network signaling are used for caller ID. If 1, the name field in the local contact
directory will be used as the caller ID for incoming calls from contacts in the local directory. Note: Outgoing calls
and corporate directory entries are not matched.
Polycom, Inc.
1
1
1
1
Permitted Values
0 or 1
0 or 1
1, 2, 3, 4
0 or 1
0 or 1
0 or 1
0 or 1
0, 1, 2
1 to 9999, minutes
0 or 1
0 or 1
1.1.0
Default
0
0
max 4
0
0
0
0
0
15
0
1
321