Rxqos - Polycom CX5500 Administrator's Manual

Polycom CX5500 Unified Conference Station Administrator's Guide
Parameter
voice.qualityMonitoring.collector.enable.triggeredPeriodic
If 0, alert states do not cause periodic reports to be generated. If 1, periodic reports are generated if an alert state
is critical. If 2, period reports are generated when an alert state is either warning or critical. Note: This parameter
is ignored when voice.qualityMonitoring.collector.enable.periodic is 1, since reports are sent
throughout the duration of a call.
voice.qualityMonitoring.collector.period
The time interval between successive periodic quality reports.
voice.qualityMonitoring.collector.server.x.address
The server address
voice.qualityMonitoring.collector.server.x.port
The server port.
The server address and port of a SIP server (report collector) that accepts voice quality reports contained in SIP
PUBLISH messages. Set x to 1 as only one report collector is supported at this time.
voice.qualityMonitoring.rtcpxr.enable
If 0, RTCP-XR packets are not generated. If 1, the packets are generated.
1
Change causes phone to restart or reboot.
<rxQoS/>
The following table lists the jitter buffer parameters for wired network interface voice traffic, wireless
network interface voice traffic, and push-to-talk interface voice traffic.
Voice Jitter Buffer Parameters
Parameter
1
voice.rxQoS.avgJitter
The typical average jitter.
voice.rxQoS.maxJitter
The maximum expected jitter.
The average and maximum jitter in milliseconds for wired network interface voice traffic.
avgJitter – The wired interface minimum depth will be automatically configured to adaptively handle this level
of continuous jitter without packet loss.
maxJitter – The wired interface jitter buffer maximum depth will be automatically configured to handle this
level of intermittent jitter without packet loss.
Actual jitter above the average but below the maximum may result in delayed audio play out while the jitter buffer
adapts, but no packets will be lost. Actual jitter above the maximum value will always result in packet loss. Note
that if legacy voice.audioProfile.x.jitterBuffer.* parameters are explicitly specified, they will be
used to configure the jitter buffer and these voice.rxQoS parameters will be ignored.
Polycom, Inc.
1
1
1
Permitted Values
0 to 80
1
0 to 200
Permitted Values
1
0 to 2
5 to 20
1
Dotted-decimal IP
address or
hostname
1 to 65535
0 or 1
Default
0
20
Null
5060
0
Default
20
160
1.1.0
332