Polycom CX5500 Administrator's Manual page 248

Polycom CX5500 Unified Conference Station Administrator's Guide
Parameter
device.net.etherModeLAN
The LAN port mode that sets the network speed over Ethernet. HD means half-duplex and FD means full duplex.
Note: Polycom recommends that you do not change this setting.
device.net.etherModePC
The PC port mode that sets the network speed over Ethernet. If set to Disabled, the PC port is disabled. HD
means half duplex and FD means full duplex.
device.net.etherStormFilter
If 1, DoS Storm Prevention is enabled and received Ethernet packets are filtered to prevent TCP/IP stack
overflow caused by bad data or too much data. If 0, DoS Storm Prevention is disabled.
1
device.net.ipAddress
The phone's IP address. Note: This parameter is disabled when DHCP is enabled (device.dhcp.enabled is
set to 1.
1
device.net.IPgateway
The phone's default router.
device.net.lldpEnabled
If set to 1, the phone will attempt to determine its VLAN ID and negotiate power through LLDP.
device.net.subnetMask
The phone's subnet mask. Note: This parameter is disabled when DHCP is enabled (device.dhcp.enabled is
set to 1).
1
device.net.vlanId
The phone's 802.1Q VLAN identifier. If Null, no VLAN tagging.
1
device.pacfile.data
EAP-FAST only, optional. The PAC file (base 64 encoded). To generate a base 64-encoded PAC file, generate
the PAC file using your authentication server and then convert it to base 64. You can convert the file to base 64
using the following openssl commands:
$ openssl enc -base64 -in myfile -out myfile.b64
device.pacfile.password
EAP-FAST only, optional. The password for the PAC file.
device.prov.maxRedunServers
The maximum number of IP addresses that will be used from the DNS.
Polycom, Inc.
1
1
1
1
1
1
1
Permitted Values
Auto, 10HD, 10FD,
100HD, 100FD, 100FD
Disabled, Auto, 10HD,
10FD, 100HD, 100FD,
100FD
0 or 1
string
dotted-decimal IP
address
0 or 1
dotted-decimal subnet
mask
Null, 0-4094
String
String
1 to 8
1.1.0
Default
Null
Auto
Null
Null
Null
Null
Null
Null
Null
Null
Null
248