Huawei S1700 Series Web User Manual page 87

S1700 Managed Series Ethernet Switches
Web User Manual
Item
Static Interface
Eth- Trunk List
Step 3 Configure the needed parameter.
Step 4 Click Apply button to apply all the changes made.
----End
Batch Create Static Groups
Step 1 Click Service Management> IGMP Snooping> Static Groups.
Step 2 Click Batch Create button, opening the configuration page shown as the figure below.
Figure 5-43 Batch Create Static Groups
Table 5-30 Parameters of IGMP Snooping Static Groups
Item
VLAN
Start Group Address
End Group Address
Static Interface
Eth-Trunk List
Step 3 Configure the needed parameter.
Step 4 Click Apply button to apply all the changes made.
Issue 05 (2012-10-25)
Description
Select interface for receiving this static multicast group.
Select Trunk for receiving this static multicast group data.
Description
Specify VLAN for transmitting multicast service.
Batch creation of start IP address for new static multicast group.
Batch creation of the end IP address for new static multicast
group.
Select interface for receiving this static multicast group data.
Select Trunk for receiving this static multicast group data.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Service Management
77