Huawei S1700 Series Web User Manual page 224

S1700 Managed Series Ethernet Switches
Web User Manual
Figure 11-9 Interface Mirror
Table 11-7 Parameters of Interface Mirror
Item
CPU Mirror
ACL Name
Frame Type
Interface List
Mirror RX data of interface 1 to interface 2
Step 1 Click Device Management > Interface Mirror.
Step 2 Click on the check box on the left side of the interface list and select RX in Frame Type drop
down menu.
Step 3 Select source port of interface mirror in Source Interface, here is Ethernet0/0/1.
Step 4 Select destination port of interface mirror in Destination Interface, here is Ethernet0/0/2.
Step 5 Click Add or Apply button to apply all the changes made. After successful configuration, all
the packets received by port 1 will be forwarded to port 2.
----End
Issue 05 (2012-10-25)
Description
Indicates that the switch copies all the frames received by CPU to
destination interface, and the mapped data are always VLAN tagged.
Enter an ACL name and click Add or Apply button. Flow mirror is based
on an ACL name only, and the ACL name can be non-existent, but cannot
bind multiple ACL names at the same time. The binding relation still does
exist after ACL name is deleted.
There are three options: Both, RX, TX. Use drop-down menu to select
these options.
Select the source and destination interface to be imaged from the interface
list. Press Ctrl or Shift to select multiple source interfaces, the destination
interface can only be one, all the source and destination interfaces can
support Eth-Trunk. Click Add or Apply button after finished. Interface
mirror can support Eth-Trunk, but the trunk member cannot be configured
independently. The interface will recover original attribute after it is
removed from trunk or trunk is deleted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Device Management
214