Chapter 3. Configuration; Port; 3-1.1 Configuration - Manufacture Technology GEFXL2-CSW28KX User Manual

Chapter 3.
This chapter describes all of the basic network configuration tasks which includes the
Ports, Layer 2 network protocol (e.g. VLANs, QoS, IGMP, ACLs and PoE etc.) and
any setting of the Switch.

3-1 Port

The section describes to configure the Port detail parameters of the switch. Others you could
using the Port configure to enable or disable the Port of the switch. Monitor the ports content
or status in the function.

3-1.1 Configuration

This chapter describes how to view the current port configuration and how to configure ports to
non-default settings, including
Linkup/Linkdown
Speed (Current and configured)
Flow Control (Current Rx, Current Tx and Configured)
Maximum Frame Size
Excessive Collision Mode
Power Control.
Web Interface
To configure an Current Port Configuration in the web interface:
1. Click Configuration, Port, then Configuration
2. Specify the Speed Configured, Flow Control , Maximum Frame sze ,
Excessive Collision mode and Power Control.
3. Click Save.
Figure 3-1.1: The Port Configuration
Configuration
36 Publication date: March, 2012
Revision A1