3-6.6 Ipv6 Ssm Information - Manufacture Technology GEFXL2-CSW28KX User Manual

3-6.6 IPv6 SSM Information

The section describes the user to configure the Entries in the MLDv2 Information Table are
shown on this page. The MLDv2 Information Table is sorted first by VLAN ID, then by group,
and then by Port No. Diffrent source addresses belong to the same group are treated as
single entry.
Each page shows up to 64 entries from the MLDv2 SSM (Source Specific Multicast)
Information table, default being 20, selected through the "entries per page" input field. When
first visited, the web page will show the first 20 entries from the beginning of the MLDv2
Information Table. The "Start from VLAN", and "group" input fields allow the user to select the
starting point in the MLDv2 Information Table.
Web Interface
To display the MLDv2 IPv6 SSM Information in the web interface:
1. Click Configuration, MLD Snooping, IPv6 SSM Information
2. If you want to auto-refresh the information then you need to evoke the
"Auto-refresh".
3. Click " Refresh" to refresh a entry of the MLDv2 IPv6 SSM Information.
4. Click "<< or >> " to move to previous or next entry.
Figure 3-6.6: The IPv6 SSM Information
Parameter description:
MLDv2 Information Table Columns
VLAN ID :

VLAN ID of the group.
Group :

Group address of the group displayed.
Port :

Switch port number.
Mode :

Indicates the filtering mode maintained per (VLAN ID, port number, Group Address) basis.
It can be either Include or Exclude.
Source Address :

IP Address of the source. Currently, system limits the total number of IP source addresses
for filtering to be 128.
Type :

Indicates the Type. It can be either Allow or Deny.
107
Publication date: March, 2012
Revision A1