Manufacture Technology GEFXL2-CSW28KX User Manual page 274

Users :

Each of the user modules has a column that shows whether that module has enabled Port
Security or not. A '-' means that the corresponding user module is not enabled, whereas a
letter indicates that the user module abbreviated by that letter (see Abbr) has enabled port
security.
State :

Shows the current state of the port. It can take one of four values:
Disabled: No user modules are currently using the Port Security service.
Ready: The Port Security service is in use by at least one user module, and is awaiting
frames from unknown MAC addresses to arrive.
Limit Reached: The Port Security service is enabled by at least the Limit Control user
module, and that module has indicated that the limit is reached and no more MAC
addresses should be taken in.
Shutdown: The Port Security service is enabled by at least the Limit Control user module,
and that module has indicated that the limit is exceeded. No MAC addresses can be
learned on the port until it is administratively re-opened on the Limit Control configuration
Web-page.
MAC Count (Current, Limit) :

The two columns indicate the number of currently learned MAC addresses (forwarding as
well as blocked) and the maximum number of MAC addresses that can be learned on the
port, respectively.
If no user modules are enabled on the port, the Current column will show a dash (-).
If the Limit Control user module is not enabled on the port, the Limit column will show a
dash (-).
Indicates the number of currently learned MAC addresses (forwarding as well as blocked)
on the port. If no user modules are enabled on the port, a dash (-) will be shown.
Auto-refresh :

To evoke the auto-refresh icon then the device will refresh the information automatically.
Upper right icon (Refresh):

You can click them for refresh the Port Security Switch Status information by manual.
264 Publication date: March, 2012
Revision A1