Eps - Manufacture Technology GEFXL2-CSW28KX User Manual

3-23 EPS

The chapter describes the Ethernet Protection Switching (EPS). The switch supports the
Ethernet (Linear) Protection Switch instances are configured here.
Web Interface
To configure the EPS in the web interface:
1. Click Configuration, EPS
2. Click Add new EPS then you can create new EPS entry on the switch.
3. Assign each parameter to add new EPS.
4. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
5. Click Refresh then switch will update the EPS table by manually.
Figure 3-24.1: The EPS Configuration.
Parameter description:
Delete:

This box is used to mark a EPS for deletion in next Save operation.
EPS ID:

The ID of the EPS. Click on the ID of an EPS to enter the configuration page.
Domain:

You can scroll to select the domain with "Port", " Esp" . "Evc" and "Mpls"
Port: This will create an EPS in the Port Domain. 'W/P Flow' is a Port.
Esp: Future use
Evc: This will create an EPS in the EVC Domain. 'W/P Flow' is an EVC.
Mpls: Future use
Architecture:

The field you can scroll to select architecture of EPS as"1+1" or "1:1".
(needs to upgrade FW then will support it)
(needs to upgrade FW then will support it)
214 Publication date: March, 2012
Revision A1