4-2 ARP Insprction
The section describes to configure the ARP Inspection parameters of the switch. You could
use the ARP Inspection configure to manage the ARP table.
4-2.1 Configuration
This section describes how to configure ARP Inspection setting including:
Mode (Enabled and Disabled)
Port (Enabled and Disabled)
Web Interface
To configure an ARP Inspection Configuration in the web interface:
1. Select "Enabled" in the Mode of ARP Inspection Configuration.
2. Select "Enabled" of the specific port in the Mode of Port Mode
Configuration.
3. Click Save.
Figure 4-2.1: The ARP Inspection Configuration
Parameter description:
Mode of ARP Inspection Configuration :
Enable the Global ARP Inspection or disable the Global ARP Inspection.
Port Mode Configuration :
Specify ARP Inspection is enabled on which ports. Only when both Global Mode and Port
Mode on a given port are enabled, ARP Inspection is enabled on this given port.
Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
228
Publication date: March, 2012
Revision A1