Chapter 4. Security; Ip Source Guard; 4-1.1 Configuration - Manufacture Technology GEFXL2-CSW28KX User Manual

Chapter 4.
This chapter describes all of the switch security configuration tasks to enhance the
security of local network including IP Source Guard, ARP Inspection,DHCP Snooping,
AAA, and etc..

4-1 IP Source Guard

The section describes to configure the IP Source Guard detail parameters of the switch. You
could use the IP Source Guard configure to enable or disable with the Port of the switch.

4-1.1 Configuration

This section describes how to configure IP Source Guard setting including：
Mode (Enabled and Disabled)
Maximum Dynamic Clients (0, 1, 2, Unlimited)
Web Interface
To configure an IP Source Guard Configuration in the web interface:
1. Select "Enabled" in the Mode of IP Source Guard Configuration.
2. Select "Enabled" of the specific port in the Mode of Port Mode
Configuration.
3. Select Maximum Dynamic Clients (0, 1, 2, Unlimited) of the specific port
in the Mode of Port Mode Configuration.
4. Click Save.
Figure 4-1.1: The IP Source Guard Configuration
Security
223
Publication date: March, 2012
Revision A1