Manufacture Technology GEFXL2-CSW28KX User Manual page 184

Port :

The logical port for the settings contained in the same row. Click on the port number in
order to configure the shapers.
Shapers (Qn) :

Shows "disabled" or actual queue shaper rate - e.g. "800 Mbps".
Shapers (Port) :

Shows "disabled" or actual port shaper rate - e.g. "800 Mbps".
Scheduler Mode :

Controls whether the scheduler mode is "Strict Priority" or "Weighted" on this switch port.
Queue Shaper Enable :

Controls whether the queue shaper is enabled for this queue on this switch port.
Queue Shaper Rate :

Controls the rate for the queue shaper. The default value is ?. This value is restricted to ?-
1000000 when the "Unit" is "kbps", and it is restricted to 1-? when the "Unit" is "Mbps.
Queue Shaper Unit :

Controls the unit of measure for the queue shaper rate as "kbps" or "Mbps". The default
value is "kbps".
Queue Shaper Excess :

Controls whether the queue is allowed to use excess bandwidth.
Queue Scheduler Weight :

Controls the weight for this queue. The default value is "17". This value is restricted to 1-
100. This parameter is only shown if "Scheduler Mode" is set to "Weighted".
Queue Scheduler Percent :

Shows the weight in percent for this queue. This parameter is only shown if "Scheduler
Mode" is set to "Weighted"
Port Shaper Enable :

Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate :

Controls the rate for the port shaper. The default value is ?. This value is restricted to ?-
1000000 when the "Unit" is "kbps", and it is restricted to 1-? when the "Unit" is "Mbps".
. Port Shaper Unit :

Controls the unit of measure for the port shaper rate as "kbps" or "Mbps". The default value
is "kbps".
. Buttons:

Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
174 Publication date: March, 2012
Revision A1