Adjustment For Long-Sized Paper; Adjustment For Short-Sized Paper - Toshiba e-STUDIO650 Service Handbook

<Procedure> (Adjustment mode) (Enter the code [see table above] with the digital keys) [START]
(Enter a value (the acceptable values: see the table above) with the digital keys)
Press the [SET] or the [INTERRUPT] key to store the value in the RAM.
"100% A" is displayed Press [1] ([3] for duplexing) [ENERGY SAVER]
(A grid pattern is printed out)
*The larger the adjustment value, the shorter the distance D becomes (0.4 mm/
steps).
(e) Image position adjustment of the primary scanning direction during duplex printing (the adjustment
of the laser writing start position)
Note: The first line of the grid pattern is occasionally not printed out.
(e-1) Adjustment for long-sized paper
1. Turn ON the power while the digital keys [0] and [5] are pressed simultaneously. (Adjustment
mode)
2. Press [3] [ENERGY SAVER] (A grid pattern is printed out on both sides of the paper: Use A3/LD
in the 2nd cassette.)
3. Check the grid pattern on the top side of the paper. Measure the distance E from the front edge of
the paper to the 6th line of the grid pattern.
4. Check if the distance E is in the range of 52 ± 0.5 mm.
5. If not, change the value taking the following procedure and measure the distance E again.
<Procedure> (Adjustment mode) (Enter the code [498] with the digital keys) Press [0] [START]
(Enter a value (acceptable values: 0 to 255) with the digital keys)
Press the [SET] or the [INTERRUPT] key to store the value in the RAM.
"100% A" is displayed.
Press [3] [ENERGY SAVER]
(Grid patterns are printed out on both sides of the paper)
*The larger the adjustment value, the longer the distance E becomes
(e-2) Adjustment for short-sized paper
1. Turn ON the power while the digital keys [0] and [5] are pressed simultaneously. (Adjustment
mode)
2. Press [3] [ENERGY SAVER] (A grid pattern is printed out on both sides of the paper: Use A3/LD
in the 2nd cassette.)
3. Check the grid pattern on the top side of the paper. Measure the distance E from the front edge of
the paper to the 6th line of the grid pattern.
JUNE 2002 © TOSHIBA TEC
(approx. 0.5 mm/10 steps).
3 - 9 e-STUDIO550/650/810 ADJUSTMENT