Adjustment Of Solenoid; Disengagement Solenoid; Small Original Exit Solenoid; Large Original Exit Solenoid - Toshiba e-STUDIO650 Service Handbook

3. 11. 3. Adjustment of solenoid

(1) Disengagement solenoid

To install the solenoid, put the end faces of the
C
bracket and solenoid together and fix the sole-
noid with two screws at the position (A) and (B).
When the large original exit roller is not disen-
gaged completely, move the screw from the
Ends faced-up
position (A) to (B) and shift the solenoid upward
to adjust the level of the disengegemrnt.
A
B

(2) Small original exit solenoid

To install this solenoid, put the end faces of the
bracket and solenoid together. When the small
original reverse flapper is not pulled at com-
pletely, loosen two screws and shift the solenoid
upward to adjust the level of the flapper move-
ment.
Ends faced-up

(3) Large original exit solenoid

To install this solenoid, put the end faces of the
bracket and solenoid together. When the large
original reverse flapper is not pulled at com-
Ends faced-up
pletely, loosen the screws and shift the solenoid
upward to adjust the level of the flapper move-
ment.
JUNE 2002 © TOSHIBA TEC 3 - 41 e-STUDIO550/650/810 ADJUSTMENT