Procedure 6
[0] [5]
[Digital key]
[POWER]
(Code)
Procedure 13
[0] [5]
[Digital key]
[START]
[POWER]
(Code)
Procedure 15
[0] [5]
[Digital key]
[POWER]
(Code)
Note: The fuser roller temperature control is different from it at the normal state. Therefore, the problem of
fusing efficiency may be occured in the test copy at the adjustment mode.
In that case, turn ON the power normally, leave the copier for approx. 3 minuites after it has become
ready state and then start up the adjustment mode again.
JUNE 2002 © TOSHIBA TEC
Automatic
[START]
adjustment
[CANCEL]
[Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
Automatic
[START]
adjustment
[CLEAR]
2 - 21 e-STUDIO550/650/810 ERROR CODES AND SELF-DIAGNOSIS
[POWER]
OFF/ON
(Exit)
[SET]
[ENERGY
[Digital key]
or
* [JOB STATUS] key
[INTERRUPT]
(Stores value in
RAM)
Enter a
[CLEAR]
value
(Corrects value)
* Press [JOB STATUS] to enter "–".
[SET]
[POWER]
or
OFF/ON
[INTERRUPT]
(Exit)
(Stores value in
RAM)
[POWER]
SAVER]
OFF/ON
Test
(Exit)
copy