Adjustment Of Paper Aligning Value - Toshiba DP1600 Service Handbook

1.4.1 Adjustment of paper aligning value

<Procedure> (Use code 450 - 453, 455, 456, 457, 458, 463, 465 in the "05" mode.)
Cassette 1
(Long)
If necessary
450
ADU
455
(1)
0 5
Digital Keys
Power ON
(Code)
(2) Check the copy for image void and if there is
any, reduce the new value to "31"
"29"... until no void occurs. Check for paper
misfeeding.
When the aligning value is increased, noise
caused by the paper scraping against the Mylar
may possibly be increased.
(3) For the LCF, ADU and bypass, the same pro-
cedure can be used.
Notes: 1. When frequent paper jams occur near the aligning roller caused by using special thin paper
other than that specified, the aligning value can be changed (reduced) as a measure. However,
when the aligning value is reduced excessively, this may possibly cause the registration to be
shifted. Therefore, make sure that no registration shifting occurs while adjusting the value.
2. Long size adjustment is used as the base when there are both long and short adjustments.
3. Adjusts the code only for option attached.
* As a tentative countermeasure, the service life of the feed roller can be extended by increasing the
aligning amount.
December 2000 © TOSHIBA TEC
Cassette 1
(Short)
451
PFP
LCF
(Short)
456
457
SET Digital Keys
or
(Set the value)
START
"30"
1 - 55
02/01
Cassette 2 Cassette 2
(Long) (Short)
452 453
Bypass PFP
(Short) (Long)
458 463
SET INT
or
START
Void
1600/2000/2500 ADJUSTMENT ITEMS
Bypass
(Long)
465
START INT
(Test copy)
01-04-02