Trailing Edge Of Paper Not Passing The Exit Sensor - Toshiba e-STUDIO650 Service Handbook

[E5A] Trailing edge of paper not passing the exit sensor
Is there any paper at the reverse section when the exit cover is opened?
YES
NO
Is the exit motor driving? (Perform the output check in the test mode: 03-120)
NO
YES
1. Check if the setting of the paper size is correct.
2. Check if there is no abnormality and extraneous material at the guide and myler in front of the
exit roller.
3. Check if there is no mechanical loading at the exit follower roller.
e-STUDIO550/650/810 TROUBLE SHOOTING
Remove the paper.
1. Check if the connector of the exit motor is not disconnected.
2. Check if the connector J336 on the LGC board is not disconnected.
3. Check if the connector pins are not disconnected and the harness is not
open-circuited.
4. Check if the conductor pattern on the LGC board is not short- or open-
circuited.
5. Replace the LGC board.
5 - 32 JUNE 2002 © TOSHIBA TEC