[ E C A ] Paper remaining at the inserter when the power is ON
Is there any paper remaining at the inserter transport path?
YES
NO
Are the separation sensor, reverse path sensor and transport sensor working improperly?
YES
NO
Replace the inserter control board.
[ECB] Inserter size difference jam
Is the paper size on the inserter tray consist with the size set at the copier control panel?
YES
NO
Is the separation sensor working improperly?
YES
NO
Perform the width adjustment of the inserter tray side guide.
[ECC] Inserter feeding jam
Is the condition improved when the copier power switch is turned OFF/ON?
NO
1. Replace the copier LGC board.
2. Replace the IPC board.
3. Replace the inserter control board.
e-STUDIO550/650/810 TROUBLE SHOOTING
Remove the paper.
Replace the sensors.
Set the same paper size as that on the tray.
Replace the separation sensor.
5 - 52
JUNE 2002 © TOSHIBA TEC