Assist Mode; Clear Nvram Flags; Format A Language Partition - Toshiba e-STUDIO650 Service Handbook

* If an error occurs while the processing of automatically sequenced writing of #4, do the following
operations after completing the update in a recovery mode.
Target Area of error
#4 1~9 After completing the update to the target 9 in a recovery mode, update the
target 10 to 13 in a writing processing with the area definition.
#4 10~13 Uupdate the target 10 to 13 in a writing processing with the area definition.

11. Assist mode

This mode has the following two functions.

(1) Clear NvRAM flags.

Even if download normally completed, Recovery mode start up when the power ie turn on again.
In this case, start up this mode, clear NvRAM flags which was used in download process.
(Normally, flags are automatically cleared in download process)
And, in the case the recovery mode is strat up when SYS-NVM is replaced etc..

(2) Format a Language Partition

This mode is used, in the case that UI data is downloaded which PC after replacing HDD. It is
necessary to make the partition on HDD before downloading.
Note: 1.It is not necessary to make partition in the case of downloading through the Print board Jig.
2:Since this operation delete all the data in HDD, perform this format only when brand-new HDD is
installed.
<Operation procedure>
(1) Turn on the power with pressing [3] and [CLEAR] simultaneously. (Displayed as bellow)
(2) Press [START] key after selecting the number with digital key.
JUNE 2002 © TOSHIBA TEC
Operation
Firmware Version Up Mode
Select Number(1-2) and Press START key.
> 1:Clear NvRAM flags.
> 2:Format a Language Partition.
6 - 27 e-STUDIO550/650/810 FIRMWARE UPDATING