[CC4] Abnormal swing motor
[Procedure 1]
Rotate the swing motor in reverse by hand. Does the swing guide move up and down?
NO
YES
Is the swing guide closed detection switch-2 (MS6) working normally?
NO
YES
Is the swing guide open sensor (PI18) working normally?
NO
YES
Is the swing motor (M7) rotating in reverse at the fixed timing?
NO
YES
END
[Procedure 2]
Is the safety zone switch (MS3) working normally?
NO
YES
Is the safety zone switch (MS3) correctly pressed?
NO
YES
Is the swing guide closed detection switch-2 (MS6) working normally?
NO
YES
Is the swing guide closed detection switch-2 (MS6) correctly pressed?
NO
YES
Replace the finisher controller PC board.
e-STUDIO550/650/810 TROUBLE SHOOTING
Fix the swing mechanism.
Replace the switch.
Replace the sensor.
Replace the motor.
Replace the switch.
Fix the mechanism.
Replace the switch.
Fix the mechanism.
5 - 96
JUNE 2002 © TOSHIBA TEC