Adjustment Of Paper Aligning Value - Toshiba 2460 Service Handbook

1.5.1 Adjustment of paper aligning value

If necessary, you can extend the feed roller life slightly by increasing the paper aligning value.
<Procedure> (Use code 450~458 in the "05" mode.)
Copier cassette
Upper Lower
A
(Long) (Long)
(450) (452)
If necessary
A A
(1)
0 5 4
(Cassette)
PWR
E/S
(Test copy)
(2) Check the copy for image void and if there is
any, reduce the new value to "31" → "30" →
"29"... until no void occurs. Check for paper
misfeeding.
When the aligning value is increased, noise
caused by the paper scraping against the
mylar may possibly be increased.
(3) For the LCF, ADU and pedestal, the same pro-
cedure can be used.
Notes: 1. When frequent paper jams occur near the aligning roller caused by using special thin paper other than
that specified, the aligning value can be changed (reduced) as a measure. However, when the aligning
value is reduced excessively, this may possibly cause the registration to be shifted. Therefore, make sure
that no registration shifting occurs while adjusting the value.
2. Long size adjustment is used as the base when there are both long and short adjustments.
2460 ADJUSTMENT
ADU
A
(Long)
(454)
Copier cassette
Upper Lower
(Short) (Short)
(451) (453)
5 0
START
(Current value)
0 9
A
PFP LCF
(456) (457)
ADU
A
(Short)
(455)
08 1 5
(New value)
Void
1 - 26
A A
Bypass
(458)
INT Cassette
(Memory set)
September 1997 © TOSHIBA CORP.