Adjustment Of Exit/Reversal Unit; Adjustment Of Sideways Deviation At Reverse Discharging - Toshiba e-STUDIO650 Service Handbook

3. 10. Adjustment of Exit/Reversal Unit

3. 10. 1. Adjustment of sideways deviation
at reverse discharging
When a paper sideways deviation occurs at
reverse discharging, the transport guide position
is adjusted through the following procedure.
(1) Open the exit side door.
(2) Loosen 6 screws fixing the transport guide.
(3) Remove 2 screws, and take off the plate.
(4) Set the plate lengthwise, and fix it again with
2 screws after adjusting the plate installing
position depending on the paper deviation
amount.
(5) Remove 2 screws, and take off the plate with the latch holder.
(6) Turn the latch holder to the opposite direction, and install it to the plate.
(7) Turn the plate upside down (with the long hole upside), and install it again with 2 screws after
adjusting the same amount as did in the above (4).
e-STUDIO550/650/810 ADJUSTMENT 3 - 38 June 2002 © TOSHIBA TEC