(18) Image dislocation in feeding direction
Defective area
Step
Scanner/printer adjust-
1
ment
Registration roller
2
3
Feed clutch
4
Pre-registration guide
5
JUNE 2002 © TOSHIBA TEC
Check Items
Have the printed images been out of
position in the same manner?
Is the registration roller dirty, or the spring
detached?
Is the registration roller moving normally?
Is the feed clutch working properly?
Is the pre-registration guide installed prop-
erly?
5 - 127
Prescription
Adjust the position of the leading edge of paper in
the adjustment mode.
Clean the roller with alcohol.
Securely attach the springs.
Adjust or replace the gears if they are not engaged
properly.
Check the circuit or clutch, and replace them if
necessary.
Install the guide properly.
e-STUDIO550/650/810 TROUBLESHOOTING