2Nd Cassette Misfeeding - Toshiba e-STUDIO650 Service Handbook

[E14] 2nd cassette misfeeding (paper not reaching the 2nd cassette feed sensor)
Open the feed cover. Is there any paper in front of the 2nd cassette feed sensor?
YES
Remove the paper.
NO
Is the 2nd cassette feed sensor working?
(Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[3]/[B])
NO
1. Check if the connector of the 2nd cassette feed sensor is disconnected.
2. Check if the connector J329 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the 2nd cassette feed sensor.
6. Replace the LGC board.
YES
Is the 2nd cassette feed clutch working?
(Perform the output check in the test mode: 03-202)
NO
1. Check if the connector of the 2nd cassette feed clutch is disconnected.
2. Check if the connector J329 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the 2nd cassette feed clutch.
6. Replace the LGC board.
YES
Check the 2nd cassette feed roller and separation roller. Replace them if they are worn out.
JUNE 2002 © TOSHIBA TEC
circuited.
5 - 17 e-STUDIO550/650/810 TROUBLE SHOOTING