[E13] 1st cassette misfeeding (paper not reaching the 1st cassette feed sensor)
Open the feed cover. Is there any paper in front of the 1st cassette feed sensor?
YES
NO
Is the 1st cassetter feed sensor working?
(Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[2]/[B])
NO
YES
Is the 1st cassette feed clutch working?
(Perform the output check in the test mode: 03-201)
NO
YES
Check the 1st cassette feed roller and separation roller. Replace them if they are worn out.
e-STUDIO550/650/810 TROUBLE SHOOTING
Remove the paper.
1. Check if the connector of the 1st cassette feed sensor is disconnected.
2. Check if the connector J329 on the LGC board is disconencted.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the 1st cassette feed sensor.
6. Replace the LGC board.
1. Check if the connector of the 1st cassette feed clutch is disconnected.
2. Check if the connector J329 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-
circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the 1st cassette feed clutch.
6. Replace the LGC board.
5 - 16
JUNE 2002 © TOSHIBA TEC