Paper Misfeeding - Toshiba e-STUDIO650 Service Handbook

5.1.2 Paper misfeeding

[E11] Reversed paper transport jam (paper not reaching the registration sensor at the duplex printing)
Open the bypass unit cover. Is there any paper in front of the registration sensor?
YES
NO
Is the registration sensor working?
(Perform the input check in the test mode:03-[ENERGY SAVER]ON/[4]/[E])
NO
YES
Is the reversed paper transport cluch working?
(Perform the output check in the test mode: 03-220, 221)
NO
YES
Check the rollers in the reversed papaer transport section. Replace them if they are worn out.
e-STUDIO550/650/810 TROUBLE SHOOTING
Remove the paper.
1. Check if the connector of the registration sensor is disconnected.
2. Check if the connector J341 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the registration sensor.
6. Replace the LGC board.
1. Check if the connector of the reversed paper transport clutch is disconnected.
2. Check if the connector J334 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the reversed paper transport clutch.
6. Replace the LGC board.
5 - 14 JUNE 2002 © TOSHIBA TEC