(3) Winding the wire around the pulleys
Wind the wire around the wire pulley:
a. Put the ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end of the
wire with a hook attached comes to the outside.
b. Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be wound
are as follows:
· 2 turns toward the opposite side of the boss
· 5 turns toward the boss side
Note:
Pay attention to the following when the wires are wound around the pulleys:
· Do not twist the wire.
· Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
· Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
JUNE 2002 © TOSHIBA TEC
Hook
Silver
5 turns
No space between turns
Ball terminal
3 - 27
Hook
Black
5 turns
Ball terminal
2 turns
e-STUDIO550/650/810 ADJUSTMENT