General Descriptions For Pm Procedure; Preparation; Operational Items In Overhauling; Preventive Maintenance Checklist - Toshiba e-STUDIO650 Service Handbook

4. 2. General Descriptions for PM Procedure

(1)

Preparation

a. Ask the user about the current machine conditions and note them down.
b. Before starting maintenance, make some sample copies and save them.
c. See the replacement record and check the parts needed to be replaced in the PM support mode
(6S-2) or list printing mode (9S-103).
6S-2 : [6]+[START]+[POWER]ON
9S-103 : [9]+[START]+[POWER]ON
d. Turn OFF the power and unplug the copier for sure.
(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the Service
Manual if necessary.
(3) Plug in the copier after the maintenance has been finished. Then turn ON the power and make some
copies to confirm that the copier is working properly.

4. 3. Operational Items in Overhauling

(1) Replace all the supplies.
(2) Check the components in the drive section (gears, pulleys, timing belts, etc.). Replace them with
new ones if they are damaged.
(3) Check all the adhesives such as tape and Mylars if they are damaged or have become unstuck.
Replace them with new ones if necessary.
(4) Check the performance of all the switches and sensors. Replace them with new ones if necessary.
(5) Clean inside the copier thoroughly.

4. 4. Preventive Maintenance Checklist

Symbols used in the checklist
Cleaning
A Clean with alcohol
Clean with soft pad,
cloth or vacuum cleaner
JUNE 2002 © TOSHIBA TEC
Lubrication Replacement
L Launa 40 The number of sheets
Coating consumed before
SI Silicon oil replacement
W White grease (Value x 1,000)
(Molycoat) Replace if deformed
AV Alvania No.2 or damaged
4 - 5
[2] [START]
[103] [START]
Operation check
After cleaning
or replacement,
confirm there is
no problem.
e-STUDIO550/650/810 PREVENTIVE MAINTENANCE
Date
User name
Serial No.
Inspector's
name
Remarks