Replace The Cutter Blade For Cutting - MIMAKI JV3-250 SP Operation Manual

Replace the cutter blade for cutting

Cutter blades are consumables. When the cutter blade has became blunt, replace the cutter blade
with a new one. (SPA-0107)
STEP
1. Execute [CARRIAGE out].
2. Open the front cover.
3. Replace the cutter unit that is located along-
side the carriage.
1. Loosen the screws that fix the cutter unit.
2. Remove the cutter unit.
3. Put a new cutter unit in place.
4. Tighten the screws to fix the new cutter unit.
4. Close the front cover, and push [ENTER] key.
5. The device enters the LOCAL mode.
Downloaded From ManualsPrinter.com Manuals
• The blade tip is sharp. Take care to prevent possible personal injury.
• Store the cutter blades in a place that is out of the reach of children.
Be sure to dispose of the worn-out cutter blades according to the relevant
national and local ordinances in which the device is used.
• It is recommended to place a sheet of paper under the cutter blade.
This will help find the cutter blade even if it drops.
page 5.3
STATION
MENT : CARRIAGE out
- 5.19 -