Section 6.7
Front USB Cover
Front USB Cover
Opening the Front USB Cover
For Premium Display, when using a factory-installed front USB cover (without screw), the front
surface is IP65F
manufactured by Pro-face (Model Number PFXZCDCVUS1), the front surface is IP66F
Type 1, Type 4X (Indoor Use Only) or Type 13 Enclosure.
Regardless of using a factory-installed front USB cover or a front USB cover with screw, when the
cover is open, the front surface is Type 1 Enclosure.
NOTE: The Advanced Display does not have a front USB port.
RISK OF INJURY
When opening the Front USB Cover, be careful not to injure your fingers.
Failure to follow these instructions can result in injury or equipment damage.
*1 IP65F, IP66F and IP67 are not part of the UL certification.
*2 The necessary torque is 0.5 N•m (4.4 lb-in).
Step
Action
1
Place your finger or a tool (such as a screwdriver) in the gap on the top of the front USB cover
and pull down as illustrated.
NOTE:
*1
*1
, IP67F
, or Type 1 Enclosure. When using a front USB cover (with screw
When using front USB cover (PFXZCDCVUS1 manufactured by Pro-face), loosen the top
screw using a Phillips screwdriver.
The required torque is 0.5 N•m (4.4 lb-in).
CAUTION
SP5000 Series Hardware Manual
*1
, IP67F
*2
)
*1
,
141