Usb Cable Clamp Type A (1 Port) - Pro-face SP5000 Series Hardware Manual

USB Cable Clamp Type A (1 port)

Introduction
When using a USB device, attach a USB cable clamp to the USB interface to prevent the USB
cable from being disconnected.
POTENTIAL FOR EXPLOSION
Verify the power, input, and output (I/O) wiring are in accordance with Class I, Division 2 wiring

methods.
Substitution of any components may impair suitability for Class I, Division 2.

Do not disconnect equipment while the circuit is live or unless the area is known to be free of

ignitable concentrations.
Remove power before attaching or detaching any connectors to or from this product.

Ensure that power, communication, and accessory connections do not place excessive stress

on the ports. Consider the vibration in the environment when making this determination.
Securely attach power, communication, and external accessory cables to the panel or cabinet.

Use only commercially available USB cables.

Use only non-incendive USB configurations.

Suitable for use in Class I, Division 2, Groups A, B, C, D Hazardous Locations.

Confirm that the USB cable has been attached with the USB cable clamp before using the USB

interface.
Failure to follow these instructions will result in death or serious injury.
Attaching USB Clamp Type A (1 port)
NOTE: Watch your fingers. The edge of the clip is sharp.
Step Action
1
Mount the clip to the USB mark
27 to 43.5 mm [1.06 to 1.71 in] length of the USB connector.
NOTE: When installing clamps to reduce cable stress onto both USB1 and USB2, at USB1
overlay the clip on the side with the USB mark, and on USB2 the side without the USB mark.
Make sure the ties do not interfere with the other.
DANGER
connector shell so that it overlaps. The clip matches the
SP5000 Series Hardware Manual
125