Table of Contents
Advertisement
Installation and Wiring
Step
Action
2
Align the clip and the USB cable connector shell. Adjust the position of the holes where the clip
is attached. To ensure stability, select the clip-hole position that is closest to the base of the
connector shell.
3
As shown, pass the tie through the clip hole. Next, turn the tie and pass it through the head so
that the USB cable can pass through the center of the tie loop. The clip is now attached to the
USB cable.
NOTE:
4
While pressing the grip on the clip, insert the cable from step 3 all the way into the USB host
interface. Make sure that the clip tab is secured to the USB cable attached to this product.
126
Check the direction of the head beforehand. Make sure the USB cable is through the center
of the tie loop and that the tie can pass through the head.
You can substitute the tie provided with PFXZCBCLUSA1 (manufactured by Pro-face), or
other commercially available ties with a width of 4.8 mm [0.19 in] and thickness of 1.3 mm
[0.05 in].
Advertisement
Table of Contents
